en
Startup
14
MH 5065 R
1. Move the throttle lever to the "START" posi-
tion.
2. Pull out the cable starter briskly, and then al-
low it to wind back in slowly.
Putting of Weeder Share into Operation
1. Push clutch lever up fully and hold it there.
The tiller blades may begin to turn when the
lever is only pressed halfway up.
Breaking of Weeder Share
1. Release the clutch lever.
Starting reverse drive
1. Pull up the reverse gear lever up to the stop.
Disconnection of reverse drive
1. Release the reverse gear.
Switching off the motor
1. Move throttle lever to the "STOP".
MAINTENANCE AND CARE
CAUTION!
Risk of injury!
Always switch the motor off and pull
the spark plug connector prior to any
maintenance and care work.
Motor may continue running. Make
sure that the motor has stopped af-
ter switching it off.
Always wear work gloves when car-
rying out maintenance and care jobs
on the cutting blade.
Clean the appliance after every use
Do not spray the machine with water! Pene-
trating water (ignition system, carburettor...)
can lead to malfunctions.
ADVICE
When the device is tilted to the side, the
carburettor must be pointing upwards.
Expert inspection is required:
After running into an obstacle
If the motor stops suddenly
If there is gear damage
If the V-belt is defective
If a blade is bent
If the motor shaft is bent
Changing the gear oil
In general, the gear oil should be changed every
100 operating hours. (oil viscosity SAE 80).
Oil change
1. Remove brake toe.
2. Remove screwed drain plug.
3. Tilt machine back and suck the oil off by a
pump.
4. Fill in fresh oil. Required oil quantity approx.
0,5 l.
ADVICE
In order to be able to measure the oil le-
vel, the machine has to be tilt back. The
oil has to run out of the feed opening,
shortly before the machine touches the
ground at point A .
5. Close feed opening by screwed drain plug.
Motor
Oil change / Air filter / Spark plug
See the instructions for use from the motor manu-
facturer.
Adjusting Bowden cables
The fine adjustment is made using the adjusting
screw on the upper handle and on the motor
mount (on the ends of the Bowden cables).
1. Loosen the locknuts.
2. Adjust via the adjusting screw.
ADVICE
Correct set-up:
The tiller blades may
begin to turn when the lever is only pres-
sed halfway up.
3. Re-tighten the locknuts.
Throttle cable:
See the instructions for use from the motor manu-
facturer.
STORAGE
CAUTION!
Fire hazard!
Do not store fuelled machine in buildings
where the petrol fumes might come into
contact with naked flames or sparks!
ADVICE
Only authorized specialized workshops
or our customer service are allowed to
repair the unit.
