WARNING:
Ground spikes are sharp and pose a potential drop hazard. Use proper carrying techniques to avoid
dropping the unit on the operators foot or leg.
WARNING:
The Ozzie ground monitor contains moving parts. Keep hand , finger, and objects away from moving
parts and never operate without guards.
WARNING:
The flow of water is not controlled at the monitor. Sudden flow can occur from a remote pumper
location. Stay away from DANGER ZONE as shown in (Figure 1).
WARNING:
If flow is interrupted and then reestablished oscillation will remain engaged.
WARNING:
The 2 1/2" inlet on the Ozzie is not to be connected directly to a hydrant outlet.
SET UP (INSTALLATION)
1.
Place the unit on the ground with the outlet pointed in the desired direction. Make sure all four ground spikes
are in contact with the ground.
WARNING:
DO NOT operate on metal, marble, or other hard, smooth surfaces, and make sure no obstructions are
under the unit.
2.
Disconnect the hose tie down straps and loop the hose across the legs in front of the monitor as shown in
(Figure 1).
3.
Reattach the hose tie down straps as shown in (Figure 1).
4.
Make sure a 10 ft. (3m), loop is maintained and connect the hose to the inlet swivel on the monitor as shown in
(Figure 1).
5.
With the fog tip pointed straight ahead, adjust the right and left travel with the travel control knobs. NOTE: The
left knob adjusts the right travel and the right knob adjusts the left travel.
6.
The oscillation ON/OFF knob must be pulled out for oscillation to be on.
7.
Position the fog tip against the right or left stop, and set the fog tip desired flow and pattern.
8.
Unlock the elevation knob and position the outlet to the desired elevation. Lock the elevation position by
twisting the elevation knob.
2
