AKM AKD4114-B, Manual

Page: 14 / 30

[AKD4114-B]
[KM076604] 2009/08 - 14 -
[Sequence]
Click [Sequence] button to open register sequence setting dialog box.
Register sequence can be set in this dialog box.
Figure 9. Window of [ Sequence ]
Sequence Setting
Set register sequence by following process bellow.
(1)Select a command
Use [Select] pull-down box to choose commands.
Corresponding boxes will be valid.
< Select Pull-down menu >
· No_use : Not using this address
· Register : Register writing
· Reg(Mask) : Register writing (Masked)
· Interval : Taking an interval
· Stop : Pausing the sequence
· End : Finishing the sequence
(2)Input sequence
[Address] : Data address
[Data] : Writing data
[Mask] : Mask
[Data] box data is ANDed with [Mask] box data. This is the actual writing data.
When Mask = 0x00, current setting is hold.
When Mask = 0xFF, the 8bit data which is set in the [Data] box is written.
When Mask =0x0F, lower 4bit data which is set in the [Data] box is written.
Upper 4bit is hold to current setting.
[ Interval ] : Interval time