Page 33 of 68
Install the Control Cable Connectors and Controller Socket
Insert the 10 pin cable connector, P6. Make sure to match up the pin numbers on the silk
screen with the pins on the connector as shown in Figure 22.
Figure 22-10 pin cable connector pinout
Solder two corner pins, and make sure that you’ve got it right one more time
before you solder the remainder of the pins.
Check to see that the connector sits flat on the board. If it doesn’t, melt the solder
joint on one or both corner pins and adjust the connector until it does sit flat.
Insert the 16 pin cable connector, P7. Make sure to match up the pin numbers on the silk
screen with the pins on the connector as shown in Figure 23.
Solder two corner pins, and make sure that you’ve got it right one more time
before you solder the remainder of the pins.
Check to see that the connector sits flat on the board. If it doesn’t, melt one or
both corner pins and adjust the connector until it does sit flat.
Figure 23-locating the pins on the 16 pin cable connector
Next, install and solder the 20 pin socket into the silkscreen into U4.
Make sure that the
indented feature in the socket matches the indentation in the silk screen. (In
Figure 24
we’ve added a gray line to the socket
to emphasize the indentation).
