Page 17 of 68
7.
When you look at the front of the chassis, the tape should not be visible.
8.
Remove the “3M” paper backing from the double-sided tape.
9.
Press the black plastic window against the newly exposed sticky side of the tape,
being careful to center the window on the tape. Please note that the hole is rather
smaller than the window, so there is reasonable room for error.
10.
If you’re satisfied with the window position, press it firmly against the chassis to
seat it well in place.
Install Back Panel Power Connectors and Front Panel Power
Switch
The switched outlet, non-switched outlet, and IEC power input connector push into the
chassis from the outside and are retained by an amazingly effective built-in spring clip
mechanism. Install these three items in the orientation shown in Figure 12. Make sure
