Ultrasonic Fuel Level Sensor Manual
Updated until firmware 405p & 1.0.3816
- 12 -
The acoustic protrusion should be positioned in the tank aperture in the center of
the hole. The protrusion should ideally be protruding into the tank and not be
recessed in the hole. See drawing above.
For tightening screws ensure base and washers are sitting flat. Tighten screw
until screw head makes contact with the washer, and then tighten another 2 full
turns.
Maximum torque for the mounting screws is 0.5 Newton meter.
Note: Drawing is not to scale. Please use the tank gasket as a template and make
sure the tank hole is 42mm.
