29
More in detail about adjustment of gauges it is described in section the Built in
program of adjustment of gauges on p. 38.
DYNAMIC AND STATIC OPERATING MODES
Dynamic mode is the main mode of operation of the detector. It is characterized in
that the processor constantly adjusts to relatively slow changes in ground conditions.
Therefore, in this mode, the instrument responds to the desired objects only when moving the
coil. If the coil is stationary over an object after a while the sound will disappear. This is the
primary mode your detector is in every time you turn it on. The speed of auto fine tuning of
the ground is based upon the AGB parameter, the level of soil mineralization, the
heterogeneity of the soil mineralization and the sweep speed of the coil. (see
Parameter "
AUTOFINE TUNING
" on p. 18).
Pressing the button [ ], enters the pinpoint mode in which auto fine tuning is
disconnected. The lcd display will now display the pinpoint mode screen (a Fig. 30).
TURBO
WITH
3
57
Fig. 30
Prior to initiating the pinpoint mode it is necessary to locate the approximate
position of the target. Then move the coil off to one side and press the [ ]. Pressing the
button should occur in a location where there or no metal objects under or near the edge opf
the coil. Once the pinpoint mode is enabled it is important to keep the coil at a constant
search height and parallel to the the ground and to avoid lfiting or lowering of the coil
while pinpointing.
To disable the pinpoint mode press the [ ] button. If the parameter
Pinpoint
Automatic
has been enabled then the pinpoint mode will be disabled and returned to the
normal search mode after the selected amount of time.
To adjust for optimum operation of the pinpoint mode see section
Pinpoint Gain
(page 30).
31
32
