15
М=002
БГ: +003
A
Fn: +180
Fig. 15
In the right top part of the indicator the phase of balance of a ground is
represented in Degrees.
On top left – The level of ground mineralization in standard units.
On bottom left - Ground balancing mode (
A
- Automatic,
Р
-Manual).
4. Slowly and smoothly lower the coil to the ground avoiding touching grass,
stones, etc. Lower the coil at a speed of 1 to 2 seconds from the raised to
lowered position.
Upon lowering the coil to the ground, on the display, will appear a line in the
screen left-hand side (a Fig. 16). Lower the coil until the line reaches the display
left edge.
М=102
БГ: +005
AD
Fn: +180
Fig. 16
5. At successful balancing, the device will play a melody
6. Press the button [
GB
] for transition to standard search mode;
7. If ground balance was not successful raise the coil waste high and wait 2-3 seconds
( ground line will retract to a small circle in center of screen). Repeat steps 4-6.
To enter the manual ground balance mode press either the + or - buttons. This
will allow you to adjust the ground balance point achieved in the automatic ground
balance procedure. The automatic GB procedure will be turned off and parameter
SPEED AGB
will now be set to
OFF.
To return to previously set Speed AGB values
either perform automatic ground balance procedure again or simply access Speed AGB