Chapter 3 – Maintenance
Service manual AJP PR3/PR4 3 - 7
Thoroughly flush the oil filter in non-
flammable solvent or high flash point, until all
the accumulated waste is removed.
To completely clean the filter, use
compressed air.
Before installing the oil filter, inspect carefully
for damage and make sure the rubber seal is
in good condition.
Assembly
Install the oil filter and the spring in the
correct position while keeping the rubber seal
faced to the engine inside housing as shown
in the following figure.
Install the oil filter case and tighten with the
specified torque.
! DANGER !
Putting the oil filter in a wrong position can
lead to serious engine damage.
Tightening torque: 25N.m (2,5Kgf.m)
Clean the oil glass.
Introduce by the oil filler cap the correct
quantity of the recommended engine oil.
Note:
Use an appropriate funnel to put the oil
into the engine by the plug hole on the right
crankcase cover.
OIL CAPACITY
1,0 Liters (125cc engine)
1,1 Liters (200 / 240cc engine)
Check the sealing ring on the oil cap is in
good condition; otherwise replace it with a
new O-ring.
