Chapter 6 – Engine removal / installation
Service manual AJP PR3/PR4 6 - 9
Assemble and tighten the exhaust manifold
and then the exhaust pipe (page 2 – 6);
Note:
First point the screws and the nut
on the exhaust manifold before tightening
definitively in the cylinder head and the
right beam.
Place and tighten the starter cable in the
correct position;
Place the spark plug cap;
Connect the stator connector and place it in
the correct position with the fixing bracket (or
behind the shock absorber reservoir support
in the PRO version);
Connect the rear stop switch connector and
put in its correct position on the ring of the
rear engine support;
Install the inlet nozzle and connect the
respective vacuum pipe.
Appearance of different types of nozzles / inlet
flange and the respective joint, used in
several models of PR3 and PR4.
Install the carburetor and place the vat drain
pipe in the proper position to avoid being
burned by the exhaust.
