Chapter 3
–
Maintenance
Service manual AJP PR3/PR4 3 - 42
DIGITAL SPEEDOMETER
The digital speedometer gives information on
the instantaneous speed and partial or total
distance traveled. Depending on the trading
market, the speed and distances are shown
in kilometers or miles.
To switch between the total distance for the
trip distance press the button 1. To reset the
trip distance this must be selected; press
button 1 until the value pass to zero.
CALIBRATE THE
DIGITAL
SPEEDOMETER
When the digital speedometer is replaced,
you must program the new digital
speedometer, introducing the correct
parameters according to the front wheel tire
perimeter that is fitted on the bike.
Procedure:
With the ignition key on, press both
buttons simultaneously until appears on
the display the letters "IP" on the left, and
then "+> ∂ +" on the right side
;
Press the left button to introduce the first
digit flashing the number "1" or "2" as the
measure of the front tire perimeter of the
bike;
Press the right button to change or
activate the next digit (2, 3 or 4) which
should be flashing to introduce with the
left button the appropriate number to
obtain the correct value of the requested
parameter;
After introducing the four digits
corresponding to the perimeter of the
front tire of the bike, press again the right
button to validate, exit the menu and
return to normal operation of the gauge.
Model
Front wheel
Perimeter
SM
17”
1790mm
MX
19”
1950mm
EN
21”
2200mm
To choose between kilometers and miles it
must:
Turn on the ignition key on;
Expect the speedometer to make the
starting procedure;
Press both buttons for 3 seconds;
Select "Mile" or "Km" with the left button;
Confirm your choice with right button.
MOTORCYCLE CLEANING
Clean the motorcycle regularly in order to
maintain the beauty of plastic surfaces and
prevent corrosion. The best way to do this is
to use warm water mixed with cleaning
detergent and a sponge.
The hard dirt can be removed with the help of
a plastic brush and gentle water jet.
Avoid direct high pressure jets of water
directly to the wheel bearings and
steering stem bearings and also for the
lamps in the headlight and electrical
switches or the air filter area.
Use quality detergents to clean the
motorcycle. Especially dirty parts should
be cleaned with the help of a brush.
Before washing with water, plug the
exhaust pipe to avoid getting water inside.
After washing with a soft water jet, it
should be dried with compressed air and
a cloth. Make a short ride or put the
engine running and let idling until the
engine reaches operating temperature
and actuate the brakes. By heating these
components, the remaining water will
