Ki Pro Ultra Plus File Based Recorder/Player v1.0r3 62 www.aja.com
To control Ki Pro Ultra Plus remotely, connect a computer to the Ki Pro Ultra Plus’s
LAN connector, an RJ-45 socket, via a CAT5 Ethernet cable.
To access Ki Pro Ultra Plus, enter its URL in the web browser. The URL will be the
IP address defined in Ki Pro Ultra Plus’s Network parameter menus (Note that
Config menu parameters 50.1 through 50.4 must all be configured correctly to
access Ki Pro Ultra Plus on your network). If Ki Pro Ultra Plus is using DHCP (the
default), the IP address can be found by going to parameter 50.2 and reading it
there. When Ki Pro Ultra Plus is shipped from the AJA factory, it defaults to DHCP
operation. The DHCP selection is most useful in studio settings where the camera
or cameras may be connected to an existing IT infrastructure.
If 50.1 is set to DHCP, and the DHCP server on the network fails to grant an IP
address, then Ki Pro Ultra Plus’s 50.2 DHCP Address menu parameter will display
0.0.0.0. No connection to the device can be made with this address. Check with
your network administrator if you experience issues connecting to the device
over a DHCP network.
If 50.1 is set to Default Addr, the factory default static IP address 10.65.74.65 is
used. So, if 50.1 is set to Default Addr, to see Ki Pro Ultra Plus’s web interface, you
would type the following in the web browser:
http://10.65.74.65
NOTE: Your computer or network must be configured to access this IP address. You may
need to make changes to your network settings on your host computer to access
this IP address.
Figure 17. Default IP Address Configuration
For direct connections between a computer and Ki Pro Ultra Plus, you may
elect to use the Static Addr selection. This allows you to select an IP address
for Ki Pro Ultra Plus and apply it. For example, you could enter 192.168.0.2 as
an IP address. Then, to see Ki Pro Ultra Plus’s web interface, you would type the
following in the web browser: