Page 19
Connect the ball links to the rudder control horn using a
socket head screw, nylon lock nut and a washer. Pull the
slack out of the cables and make sure the cables cross
once inside the fuselage.
Center the rudder and position it aligned to the vertical
stabilizer. Tape the rudder to the vertical stabilizer to
hold it centered.
Repeat the cable eye installation process on the rudder
end of the cables with the servo powered up and
centered. Before you crimp the crush sleeves make sure
the cable is not looped around the cable eye at the servo
end. Pull the cable snug. You do not need to make the
cable a guitar string tight.
Remove the tape from the rudder/vertical stabilizer.
Adjust the length of the cable by turning the brass cable
eyes to center the rudder and achieve the desired cable
tension.
Electric Motor
The firewall is pre drilled with a 70mm wide x 55mm hole
pattern. The marked centerlines offset to account for
the built-in thrust angle.
Use 4mm bolt and washer on the front and a nylon lock
nut and washer on the back to secure the motor box to
the fire wall. Apply removable thread locker to the bolts
during assembly.
