17
IMPORTANT SPECIAL NOTE FOR RP MODEL ONLY
Your AutoChlor® reverse polarity monitoring system is factory pre set to reverse cycle at
the completion of each 8 hours operational period. The circuitry is fi tted with a microchip
that measures the actual operating hours of the electrodes. When the chlorinator has op-
erated for the total factory designated hours in one direction it will then change (reverse)
cycle and operate in the opposite direction for the same operational time. This ensures
that the electrode plates (+ and -) each receive the same operational time, therefore
equalising and extending cell life, and ensuring adequate cleaning for each cycle.
By maintaining a watch on the indicator and warning lights, keeping the cells in a clean
state and chemically balancing your pool water regularly you are ensuring trouble free
operation of your AutoChlor® chlorination unit with the least amount of eff ort.
Normally once set, these controls do not require further adjustment except perhaps for the
seasonal ones suggested earlier.
Set your chlorine controller to achieve maximum and optimum results for your pool situation.
Please remember that an over chlorinated pool is not a healthy pool, so it may not be nec-
essary for you to run your chlorinator at maximum output to maintain recommended chlorine
levels.
Your AutoChlor® salt water chlorinator is fi tted with a sophisticated electronic circuit board
which is designed to minimise the need for manual operations and maximise cell life by con-
stantly managing the correct operation of the power supply and electrolytic cells. In addition
to the four warning lights, a warning alarm (beeper) has been installed to alert you of any
problems that the electronic monitoring system has interpreted. The alarm will activate to alert
you to any problems that have been detected, and once rectifi ed the unit will resume normal
operations.
Summary of Contents for AutoChlor Classic LS Series
Page 8: ...8 ...
Page 9: ...9 Convenient automatic inline salt water chlorination ...
