15
SMALL
FLAME
BURNER
WILL NOT
IGNITE
NO
SPARK
BURNER
WILL NOT
STAY LIT
POSSIBLE CAUSE
XXXXX
XXXXX
Empty Gas Supply
XXXXX
XXXXX
Dead Battery
XXXXX
Insufficient Gas Pressure
Electrode 1
Electrode 2
(-)
(+)
Ignition Module
(+)
(-)
Ignition Switch
R
Bk
Bk
Y/G
Y/G
Bk
W
AA Battery
SDS2 SERVICE INSTRUCTIONS
WARNING
Installation and service must be performed by a qualified installer, service agency or the
gas supplier.
WARNING
Before beginning any service of cooktop, the gas supply to the appliance must be in the
OFF position.
DO NOT MODIFY THIS APPLIANCE.
BURNERS, ORIFICES, THERMOCOUPLES,
AND ELECTRODES
1.
Remove grates by pulling up from main top of cooktop.
2.
Remove gas tubing with an 8 mm wrench. Take care to
not bend or kink gas tubing.
3.
Unscrew thumb screws from orifice holder.
4.
Lift burner head free of cooktop.
5.
Gently pull orifice holder free of cooktop.
6.
Remove gasket from orifice holder.
7.
Loosen nut retaining thermocouple using an 8 mm
wrench. Pull thermocouple quick connector free from
appropriate gas valve.
8.
Pull wire free from ignition module.
9.
Spread bottom of electrode retaining spring and pull free
from electrode.
10.
Feed electrode wire through slot in orifice holder.
11.
Unscrew orifice using a 7 mm socket.
12.
Replacement is reverse of above procedure.
VALVE AND MANIFOLD ASSEMBLY
1.
Ensure the gas supply to the cooktop is in the OFF
position.
2.
Disconnect the gas supply line to the cooktop.
3.
Remove gas tubing from each valve with an 8 mm
wrench. Take care to not bend or kink gas tubing.
4.
Pull thermocouple quick connectors free from gas
valves.
5.
Remove control knobs by gently pulling away from valve
stem.
6.
Remove valve retaining nuts using a 16 mm socket.
7.
Pull the manifold assembly free of the cooktop.
8.
Replacement is reverse of above procedure.
BATTERY REPLACEMENT
1.
Remove the battery from the battery holder located
under rear of cooktop.
2.
Insert new AA size battery into battery holder. Observe
correct polarity of battery.