
14
OPERATING INSTRUCTIONS
WARNING
The glass lid on the Suburban SDS2 Cooktop is NOT a
cooking surface. The top cover must be open when main
burner is in operation. See the warning label on the glass
lid:
COVER MUST BE IN THE FULL OPEN POSITION
WHEN ANY TOP BURNER IS IN OPERATION. AFTER
USE OF TOP BURNER(S), LET TOP BURNER GRATE
COOL BEFORE REPLACING TOP COVER.
1.
Know which knob controls which burner. Always be sure the correct burner is
turned on.
SYMBOL
DESCRIPTION
LITE / HIGH FLAME
LOW FLAME
IGNITION SWITCH
2.
Push the electronic ignition button down.
3.
Depress knob and turn counter-clockwise
to “High Flame” position.
a.
Verify sufficient gas supply before attempting to light the burner. Air in the gas
line will significantly delay burner ignition. The burner may light unexpectedly
as the air in the line clears and is replaced by Propane gas. This unexpected
ignition could burn you. Air in the gas lines may occur after the vehicle gas
bottle and/or tank is refilled, during and after servicing other appliances on
same gas line, etc.
b.
Do not attempt to light more than one burner at a time.
CAUTION
Hand held ignitors may be used but be sure they are the
type designed for lighting open flame burners.
9.764
[248]
9.764
[248]
9.173
[233]
9.173
[233]
7.047
[179]
7.047
[179]
R1.181
[R30]
R1.181
[R30]
R1.181
[R30]
R1.181
[R30]
R2.756
[R70]
18.346
[466]
R2.756
[R70]
14.094
[358]
135°
135°
SDS2
3.
If any burner should extinguish after initial lighting or due to accidental blow-out,
turn gas off by turning control knob clockwise to “OFF”, wait five (5) minutes
before attempting to relight the burner. Failure to follow these instructions could
result in a fire or explosion. If the burner should go out while cooking, or if there is
an odor of gas, turn control knob(s) clockwise to “OFF”. Wait five (5) minutes
for gas odor to disappear. If gas odor is still present - Do not relight burners. See
“What To Do If You Smell Gas” on the front cover of this manual.
4.
To turn burner(s) “OFF”, turn the appropriate control knob clockwise
to “OFF”.
WARNING
Be sure all control knobs are turned “OFF” when you are
not cooking. Someone could be burned or a fire could start
if a burner is accidently left on or unattended even if only
momentarily.
MAKING ELECTRICAL CONNECTION
LOW VOLTAGE 12 VOLTS D.C.
A.
Applicable to the following model: 3032AST
B.
Refer to Figure 4 for location of screw-type terminal.
C.
Electrical connections must be made in accordance with local codes and
regulations. In the absence of local codes and regulations, refer to the latest
edition of the National Electrical Code ANSI/NFPA 70.
D.
Make the 12 Volt D.C. electrical connection following the wiring diagram illustrated
in Figure 4.
CAUTION
This appliance must be connected to a 12V power supply. The
circuit must be fitted with a safety fuse not higher than 3 amps.
When Wiring the appliance, respect correct polarity.
WARNING
It is of utmost imporance to never connect this appliance to a higher
voltage