8
Sounds
•
3 beeps for switching OFF the Hob
[OFF_SOUND].
•
2 beeps for activating Stop & Go function
[STOP&GO_SOUND].
•
Slider sound when the power level is changed.
5.3 Switching On/Off the Hob
The hob is switched ON by touching the
[ON_OFF_KEY] for 1 sec. A beep sounds and all the
zone displays show a
‘0’.
Fig 1
If the selection of a cook set for a zone is not done in
10 seconds, the hob will be turned off automatically.
The hob is switched OFF by touching the
[ON_OFF_KEY] for 1 sec. An [OFF_SOUND] sounds
and all the zones are switched off. The purpose of
the [OFF_SOUND] is to distinguish the OFF action
over all others.
Fig 2
When the hob is OFF, after 5 sec without any error/
alarm displayed and without any message to
indicate (residual heat), the control switches off the
[KEYLOCK_LED] in order to reduce the power
consumption as much as possible.
As soon as a key is touched, the [KEYLOCK_LED]
goes ON and the hob can be operated as normal by
unlocking the keyboard and if necessary touching
the [ON_OFF_KEY] to switch ON the hob.
The [ON_OFF_KEY] will be locked to switch ON the
hob if:
−
The key lock is activated.
−
Or if there is an appliance error.
5.4 Selecting the Zone and the
Power Level
To switch on a zone requires two operations:
•
Select a zone
•
Select a desired power level
5.4.1 Selecting a zone
A zone is selected by touching the [ZONE_n_KEY] for
160ms, a beep sounds and the zone display shows
the power level.
The zones that are not selected are shown with a
dot.
Fig 3
The [ZONE_n_KEY] will be locked to select a zone if:
−
The hob is off (all zone displays are off), or
−
The key lock is activated, or
−
There is any zone or appliance error.
The zone selection will finish:
−
10 seconds after the last touch over the
[SLIDER] key.
−
If another zone is selected.
−
Or if the [ZONE_n_KEY] is touched for 160ms.
After 10 seconds of the zone selection, a beep
sounds and all the zone displays show the power
level again.
5.4.2 Selecting a Power Level for
the Zone
Once the zone is selected, the power level can be
selected by touching the [SLIDER]. Each position
over the slider surface corresponds to a power level.
The power level selection is done by sliding the
finger or placing the finger on a specific position of
the slider surface. When the power level is changed
a slider sound sounds.
