20. UPDATING A-360 INTERNAL SOFTWARE
A-360 must be at least over 90% charged before upgrading.
Otherwise the unit will not upgrade.
Download latest version of A-360 Internal Software “A-360SW_
Vx.xx” from downloads section in Airtraq website www.airtraq.com
and unzip it.
Turn On A-360 and connect to PC using the USB/Micro USB cable
provided (directly or through Docking). After a few seconds the
PC will recognize the A-360 as an external storage device called
“Airtraq Cam”.
Open “Airtraq Cam” and go to folder “System”. Copy “A-360SW_
Vx.xx” from PC to “System”.
Keep A-360 cable connected to PC and, using PC´s menus, remove
safely A-360 from PC (as usually done to remove any USB external
device).
Press and hold the On-Off button until “updating” is shown on the
A-360 screen (it will take around 20 seconds). Once the updating
process is finished (it can take seconds or a few minutes depending
on the update being performed) the screen will display “OK”
message.
Disconnect the cable between PC and A-360. Turn on A-360 and
check “System Info” to confirm the new software version is installed.
21. CLEANING INSTRUCTIONS
The A-360 is a non-critical device. Recommended cleaning is low-
level disinfection between each patient use. Be sure to follow your
institution’s specific cleaning procedures in consultation with this
manual.
1. Remove A-360 from the Airtraq and turn it OFF.
2. Cleaning: Use clean cotton gauze pads that are saturated with the
cleaning solution to wipe down the exterior surfaces of the A-360.
Use soft brushes with the cleaning solution to remove any residues
from areas that cannot be reached with the gauze pads. Be sure to
remove all visible contaminant or foreign matter. Be careful to keep
running liquid off the surfaces. The following cleaning solutions
may be used:
a. Enzymatic Cleaning Solutions (e.g.: Enzol
TM
Enzymatic
Detergent).
b. Neutral pH soap and water.
17