SS
‐
300
‐
AT
‐
C
‐
60
Installation
Guide
Solid Orange
Any
Any
Slow Blink
The AP is unable to connect to the Server.
Off
Off
Off
Off
The AP is not powered on or it is in the process of
starting up.
WLAN2
LED
will
blink
when
there
is
activity
on
the
AP
radio.
Note:
If
no
channels
are
specified
for
monitoring
and
prevention
on
the
sensor
radio,
the
respective
LED
will
have
no
activity
and
it
will
not
glow.
The
rear
panel
of
the
SS
‐
300
‐
AT
‐
C
‐
60
has
two
Ethernet
ports
‐
LAN
1
and
LAN
2,
that
enables
the
device
to
be
connected
to
the
wired
LAN
through
a
switch
or
a
hub
and
provides
the
power
for
the
device
using
802.3af
standard.
Figure 3. Rear Panel of SS-300-AT-C-60
Table 4.
Rear Panel Port Settings for SS-300-AT-C-60
Port
Description
Connector
Type
Speed/Protocol
Ethernet
(LAN1)
This enables the device to be connected to
the wired LAN through a switch or a hub.
This connection allows the SpectraGuard
Sensor to communicate with the
SpectraGuard Enterprise® Server.
This port also provides the power for the
device using 802.3af standard
RJ-45
10/100/1000 Mbps Ethernet
Power over Ethernet
Ethernet
(LAN2)
This enables the device to be connected to
the wired LAN through a switch or a hub.
This connection allows the SpectraGuard
Sensor to communicate with the
SpectraGuard Enterprise® Server.
This port also provides the power for the
device using 802.3af standard
RJ-45
10/100/1000 Mbps Ethernet
Power over Ethernet
