AirSpeed 1200 eNB Installation Guide
DUG01285
Airspan Commercial and Internal Use
26
Figure 12: Cable Preparation
5.
Secure the prepared ends of the cable into the inner part of the connector.
Figure 13: Secure Cable to Connector
6.
Line up the attached cable in preparation for closing the connector housing sections. Do not
tighten the tail nut yet.
Figure 14: Power Cable Assembled
7.
Once assembled tighten the tail nuts.
Table 9: Wire Assignment
Wire Color
Description
White
Neutral
Black
Phase
Green
Ground
1. Insert into connector, and screw shut.
2. Tighten the tail nut on to the body forcing the seal to compress around the power cable ends.
Caution:
Do not over tighten the connector or the tail nut. The connector nut should be
tightened to a torque of
no
more than 3.3 Nm (2.43 lb-ft) max.
Note:
When securing the cable verify there is no tension on the connector so that it is
easy to disconnect and re-connect for future maintenance actions.
3. Gently re-position the AC Connector so the AC Connector Clamps close onto the power cable
holding it in place.
