AirSpeed 1200 eNB Installation Guide
DUG01285
Airspan Commercial and Internal Use
21
4 Installation of AirSpeed 1200
4.1 Mounting
AirSpeed 1200 is installed on a pole or wall and comes fully assembled. Prior to installation of the
AirSpeed unit the mounting bracket must first be affixed in place.
Caution:
Proper local rigging and hoisting practices should be followed when installing the AirSpeed
1200.
Note:
Bracket extensions for when a greater distance is required from the pole due to larger pole
diameters and their intrinsic blockage, are available, consult your Airspan representative.
Note:
Pole installation should be so the antenna(s) are positioned parallel to the street for
maximum coverage.
Note:
Sector and Antenna direction are indicated on the bottom panel of the AirSpeed 1200, see
AirSpeed Bottom View
Figure 6: Positioning Overview
4.1.1 Mounting Bracket on a Non-Wooden Pole
The following images show the mounting bracket pole mount assembly for a non-wooden pole.
1.
Select the location on the pole to mount the AirSpeed 1200 mounting bracket. You can
attach the AirSpeed 1200 to any pole from 2 to 8 inch (48 to 210 mm) in diameter.
2.
Position the mounting bracket with the engagement holes facing up.
3.
Insert the clamp bands (supplied) by passing them through the upper notches and the lower
slots in the bracket, in two (2) places.
4.
Tighten the clamp bands with a large screw driver.
