AirSpeed 1200 eNB Installation Guide
DUG01285
Airspan Commercial and Internal Use
17
3 Verifying Prerequisites
Prior to installing the AirSpeed 1200, verify the required safety, power, tools, parts and components.
This chapter includes the hardware, software, and client requirements for installation.
Important:
Set up requirements for the installation is detailed in the
Job Sheet
, see
Appendix A
.
3.1 Verifying Site Requirements
To set up the AirSpeed 1200, an IP connection to a Netspan server is required.
3.2 Verify Installation Requirements
3.2.1 Verify the Tools
Table 5. Minimum Hardware Requirements
Tool
Use
Large flat bladed screwdriver
securing the pole straps
10mm or 13/32 inch wrench
for securing flange nuts
Large pliers
Tightening cable glands - To fit 15mm
Small flat blade screw driver
(insulated shaft recommended)
For AC power cable preparation
pliers
For AC power cable preparation
Knife
For AC cable preparation
Small side cutters
For AC power cable preparation
Wire strippers
For AC power cable preparation
