airpower europe GmbH, Auf der Hohl 7, D-53547 Dattenberg,
www.airpower-gmbh.com
11
Fig.4-6 Installation
on a rotary actuator
The installation steps are as follows (Fig. 4-5/ 4-6):
- Attach the mounting angle (6) to the positioner using hexagon screws (3) and washers (1).
- Attach the holder (regulator) (4)) to the shaft of the controller by means of a screw (5).
- Mount the mounting brackets (7) on the rotary actuator with the fastening screws (10) and washers (12).
- With the screw (9) you attach the appropriate picker (8) to the sprocket of the rotary actuator.
- Carefully place the positioner on the pneumatic rotary actuator. The pin of the taker (regulator (4) must be located in the opening
of the U-shaped co-driver of the actuator (8)).
- Adjust the height of the positioner, attach the screw to the pin of the holder (4)) and fix the positioner with the hexagon screw
(13), spring discs (14) and washers (15).
- Adjust the angle of rotation of the adapter (part no. 4+5+8+9). The angle must be between 45° ... 52°.
Note
1
、
Do not cover the exhaust with the mounting kit!
2. The angle of rotation of the contactor should meet the requirements of the rotary actuator.
4.3 Pneumatic connection
The pneumatic connector is located on the right side of the positioner. The positioner offers two connection types: G1/4 or NPT
1/4 (see order data). The specific type is indicated on the casing.
Select the pipe to be connected accordingly.
13 1415
