5.Periodic inspection/Maintenance
5-1
5.1
Important Items at Periodic Inspection and Maintenance or after
Maintenance
The following table shows the inspection and maintenance intervals under normal operation
conditions. When used or operated under hard environmental conditions, it is impossible to warrant
the unit even if the above conditions are performed according to the intervals listed in the above
table.
Pease wear protection implements, such as a helmet, protection glasses, earplugs, safety shoes, a
glove, and a protection-against-dust mask, according to the contents of work for safety.
Do not touch hot portions of the machine while inspecting the machine when running.
Such parts as engine, exhaust manifold, exhaust pipe, muffler, radiator, oil cooler, air-end, pipe,
separator receiver tank, and discharging pipe are especially hot, so never touch those parts,
because it could cause serious burns.
Remove the starter key from the starter switch
before starting inspection, and hang up a “Now
Checking and under Maintenance” tag where it can
be easily seen. The checker must keep the key
during checking and maintenance.
Remove the negative (–) side cable from the battery.
If the above procedure is neglected, and another
person starts operating the machine during check or
maintenance, it could cause serious injury.
Be sure to perform following periodic inspection and
maintenance:
1. Check and change compressor oil quantity
2. Change oil separator
Hang a “Now Checking and under Maintenance” tag
Prevention of oil separator from catching fire
SY001
A110290
2
1
Go
to
Discount-Equipment.com
to
order
your
parts
