1. Overview
AirLive SI-104 User Manual
2
•
Better RF range, improve about 10 meters in indoor.
•
Support 100 Kbps transmit speed, speed up communication.
1.1 Add to/Remove from Z-Wave
TM
Network
There is one button on the device. It can be used to add, remove, reset or association from
Z-Wave
TM
network.
In the first time, add the device into the Z-Wave
TM
network. First, make sure the primary
controller is in the add mode. And then power on the device, just take out the insulation
Mylar in the back side of the device. The device will auto start the NWI (Network Wide
Inclusion) mode. And it should be included in 5 seconds. You will see the LED light ON one
second.
Notice:
Including a node ID allocated by Z-Wave
TM
Controller means “
Add
” or “
Inclusion
”.
Excluding a node ID allocated by Z-Wave
TM
Controller means “
Remove
” or “
Exclusion
”.
Function
Description
Add
1.
Have Z-Wave
TM
Controller entered inclusion mode.
2.
Pressing tamper key three times within 1.5 seconds to enter the
inclusion mode.
3.
After add successful, the device will wake to receive the
setting command from Z-Wave
TM
controller about 20
seconds.
Remove
1.
Have Z-Wave
TM
Controller entered exclusion mode.
2.
Pressing tamper key three times within 1.5 seconds to enter the
exclusion mode.
Node ID has been excluded.
Reset
Notice: Use this procedure only in the event that the primary
controller is lost or otherwise inoperable.
1.
Pressing tamper key four times within 1.5 seconds and do not
release the tamper key in the 4th pressed and the red LED will
light ON.
2.
After the red LED flash 9 times, release the button within 2
seconds.
3.
IDs are removed and all settings will reset to factory default.
Association
1.
Have Z-Wave
TM
Controller entered association mode.
2.
Pressing tamper key three times within 1.5 seconds to enter the
association mode.
Note: The device supports 1 group. This group is for receiving the report
message, like triggered event etc. These groups support 8 nodes
maximum.
Summary of Contents for Z-Wave Plus SI-104
Page 1: ...SI 104 Smoke Sensor User Manual ...
Page 5: ......
