1. Overview
AirLive SI-104 User Manual
5
After updated finish,
it is recommended that the user power up the device.
Caution:
After remove the battery, please wait about 30 seconds, and then re-install the
battery.
1.6 Security Network
The device supports the security function. When the device included with a security
controller, the device will auto switch to the security mode. In the security mode, the follow
commands need using Security CC wrapped to communicate, otherwise it will not
response.
COMMAND_CLASS_BATTERY
COMMAND_CLASS_NOTIFICATION_V4
COMMAND_CLASS_ASSOCIATION_V2
COMMAND_CLASS_CONFIGURATION
COMMAND_CLASS_SENSOR_BINARY_V2
COMMAND_CLASS_WAKE_UP_V2
1.7 Test Alarm
Test the sensor by pushing firmly on the test button for around 2 seconds until the horn
sounds, the sound pattern is 3 beeps, pause, and then 3 beeps with red LED flashing
continuously and rapidly, and the controller will receive Smoke alarm test notification. If the
Smoke Sensor beeps three with yellow LED flashing three times in 43 seconds, it indicates
the Smoke Sensor is not working properly, it requires to be repaired.
This is the only way to make sure that the Smoke Sensor device is working properly. If the
device fails to test properly, have it repaired or replaced immediately. If you suspect that
your Smoke Sensor does not go into alarm, test it by pressing the test button to ensure if it
works properly.
Notice :
To keep the Smoke Sensor in good working condition, testing the device weekly is
necessary.
Summary of Contents for Z-Wave Plus SI-104
Page 1: ...SI 104 Smoke Sensor User Manual ...
Page 5: ......
