1. Introduction
AirLive OD-2060HD User’s Manual
4
1. RJ45 LAN socket:
Connect to PC or Hub/Switch.
For connections to 10Base-T Ethernet or 100Base-TX Fast Ethernet cabling. This
Ethernet port built N-Way protocol can detect or negotiate the transmission speed of
the network automatically. Please use Category 5 cable to connect the Network
Camera to a 100Mbps Fast Ethernet network switch or hub.
In the LAN socket, there are two LEDs embedded:
LAN LED (green color)
This LED will be flashing while network accessing via Ethernet.
Power (orange color)
This LED is used to indicate whether DC power is on or not. In addition, this LED will
be flashing while accessing of the Camera.
2. DI/DO connector:
DI/ DO: Connect to sensor in and alarm out devices
Cable for I/O connectors:
Name Cable
Color
Function
12VDC Brown/White
DC 12V (50mA maximum)
GND Blue/White GND
NC
Purple/White
Do not connect
NC
Gray
Do not connect
DI
Green/White
Digital signal input
DO
Orange/White Digital signal output
3. Factory Default Reset
This button is used to restore the all factory default settings. Sometimes restarting the
device will make the system back to a normal state. However, if the system still got
problems after restart, user can restore the factory default settings and install it again.
Restore the device:
(i)
Press the button down continuously.
(ii)
Hold the button at least 5s seconds and release it. Then the device has been
restored to default settings and reboot again.
Note:
Restoring the factory default setting will lose the all previous settings included IP
address forever. User needs to run the IPWizard II program to search the device and
configure it to let the device work properly again.
