Shutdown and Cleanup
12
3A1174B
Shutdown and Cleanup
Texture Spraying (5 gallon Material Hopper)
When you have finished spraying:
1.
Turn sprayer power switch (K) ON (air compressor
can remain OFF).
2.
Close gun air valve.
3.
Trigger gun into bucket until most of texture mix is
pumped out.
4.
Fill material hopper with 2-4 gallons of clean water.
5.
Spray inside material hopper to circulate water
through gun and hose. While circulating water, use
gun to clean material hopper.
6.
Spray water into a waste bucket to empty material
hopper.
NOTE: A soft brush can be used to loosen dried on
material.
7.
Turn sprayer power switch OFF.
8.
Turn air compressor ON.
9.
Open gun air valve to blow out any remaining tex-
ture residue. Flush with water.
10. Turn air compressor OFF.
NOTE: Inspect slots under machine daily for texture
material. If you find material flowing out of slots or see
material inside unit, replace pump hose immediately.
NOTE: To increase pump life, turn power off when not
spraying.
NOTICE
• Keep pump and hose clean when switching
between simulated acoustic, knockdown and
orange peel applications. A dirty pump can
release particles of texture into the finish.
• To prevent damage, before removing material
hose, be sure pressure is relieved and material
is not in hose.
• To keep unit in good operating condition,
always clean it thoroughly and prepare it
properly for storage. Do not allow material to
dry inside pump, hoses, gun or spray system
to prevent damage to equipment.
ti9202a
ti8527a
NOTICE
If water freezes in unit, damage may occur. Store
system where it will not freeze during cold weather.
ti8371a
