AirLive WL-5460AP v2 User Manual
59
he “WLAN Out Rate”
4. Enter
“VIP
Subscriber” for the “Comment”
5. Click on “Save” button
6. Now the “VIP” policy will show up in the “Current Policy Table”
Once finished, the administrator will be able to choose the policy “VIP” for their IP/MAC
Traffic Control.
. Bandwidth Control by IP address
.
is disabled
tart, please check the following area to see which client IPs are supported.
if
3. Enter “1024” for t
C
You can set the maximum bandwidth of a PC or a subscriber by using the IP Control
Please follow the procedure below to setup IP Traffi
1. Please make sure the “Interface Traffic Control”
2. Before you s
c Control
It d fers between each mode.
Please ch
are
eck this part to find out what IP addresses
supported. It varies between each mode
4.
o
lready, please choose a Policy name. The “Out Rates”
the Policy template. You cannot change the Out
Rates if you have chosen a Policy
licies. Then you
can enter the values in the “LAN”, “WLAN”, or “WAN” Out Rates.
6. Press “Save” to save settings
7. Reboot
your
AP.
* If you want to control the traffic flow between the IPs in the same interface, please make sure both IPs are
configured for the IP Traffic Control.
3. Enable the IP Control
If y u have defined a Policy a
will be automatically pasted from
5. If you want to define new Data Rate, please do not choose any po
