Air Lift SureSET 25004, Installation Manual

Page: 6 / 16

4
MN-594
SureSet
INSTALLING THE COMPRESSOR AND MANIFOLD
1. Attach the fi lter to the fi tting on the end of the compressor.
2. Ensure that the air fi ttings are properly attached to the remaining three ports on the
manifold ( fi g. 1 and fi g. 2).
Installing the SureSet System
Item Part # Description..............................Qty
A 16092 Compressor.................................. 1
B 26830 150 PSI manifold .......................... 1
C 26455 Harness ........................................ 1
D 21839 1/8” X 1/4” 90° Connector ............ 2
E 21807 1/4” X 1/4” Connector ................... 1
F 17175 1/4”-20 X 3/4 Hex cap screw ........ 2
G 18512 1/4” Lock washer .......................... 2
H 20220 ¼” dia. Black hose....................20 ft
I 10466 8” Zip tie......................................10
J 24040 ECU display ................................. 1
Item Part # Description..............................Qty
K 17318 Machine screw ............................. 1
L 18545 Lock washer ................................. 1
M 21838 Tee ............................................... 2
N 20035 Grommet....................................3.5”
O 24524 3/16”
Terminal .............................. 2
P 24542 1/4 ATC/ATO tap in fuse .............. 2
Q 24543 AGC tap in fuse ............................ 2
R 24561 Mini-fuse adapter ......................... 2
S 24594 ¼” 16 Ga. terminal ....................... 2
HARDWARE LIST
3. Select a rigid mounting location on your vehicle’s frame or cross member that shields
the compressor from the elements and heat sources ( fi g. 2).
4. Attach the compressor and manifold to the frame rail or cross member using fi g. 2 as a
guide.
The manifold should be mounted so that the transducers are facing upwards to prevent
condensation and debris from collecting in them.
5. Temporarily connect the wiring harness to the compressor and manifold to help locate
these items. This will help insure that the harness/manifold/compressor will be installed
properly. (
fi g. 1).
The compressor and manifold must be mounted within reach of the wires when the wiring
harness is plugged in.
fi g. 2
NOTE
NOTE
R R L L
Ground
The transducers should be
mounted facing upward to avoid
condensation and to prevent the
collection of debris. Note the left
and right transducers are opposite.