8
MN-594
SureSet
6. Cut a length of air line to go between the compressor and the manifold. Remove the nut
from the
fi
tting on the end of the compressor leader hose and slide it over the air line.
Attach the air line to the compression
fi
tting and tighten nut, locking the air line to the
compressor. Insert the other end of the air line to the push-to-connect
fi
tting on the end
of the manifold (
fi
g. 9).
A de
fi
nite click will be heard/felt when the air line is properly seated. The air line should go
in approximately 9/16”.
ATTACHING THE DIGITAL CONTROLLER
DO NOT PLUG THE ECU/DISPLAY CONNECTOR INTO THE DISPLAY UNIT UNTIL ALL
WIRES ARE CORRECTLY HOOKED UP. THIS WILL HELP TO PREVENT ELECTRICAL
FAILURE OF THE DISPLAY UNIT.
1. Choose a mounting location inside the cab of the vehicle for mounting the digital
controller.
This can be under the dash panel or on the dash board.
2. Attach the bracket to the chosen mounting location using the provided screws (
fi
g.
10).
3. Attach the brackets to the digital controller using the provided screws (
fi
g. 10).
4. Connect the ECU/display connector to the installed digital controller (
fi
g. 11).
5. Tighten the ECU/display connector hardware.
CAUTION
NOTE
NOTE
fi g. 10
Optional digital controller bracket mounting methods
Back view of
digital controller
ECU/display
+
–
+
–
Ground
ECU/display
connector
fi g. 11
