6
OPERATING INSTRUCTIONS
Charging the Auditor Torque Data Analyzer (ATDA)
1. Plug the 100 – 240 VAC Charger into DC Power Supply port
(Figure 2)
2. Plug the Charger into a 100 – 240 VAC power outlet using the appropriate plug end.
3.
Press the Off / Charge button on the front panel
(Figure 1)
4. The Charging Mode Indicator LED should begin to flash green.
symbol will be displayed on the Main Display screen when the unit is on and plugged in to AC
power.
5. When the ATDA is fully charged the LED will stop flashing
6. The ATDA can be used as normal in AC mode with the charger connected.
7. When the Auditor internal battery is close to requiring a recharge, the
symbol will show on the
Main Display screen. Recharge time is approximately 4-5 hours and can be done while the unit is in
use and on AC power.
Basic Navigation and Use of the Keypad
Many functions of the
Auditor ATDA
can be accessed by using the button directly below the
associated text on the display screen. For example, if the following screen were displayed:
the
LEFT SELECTION BUTTON
, which is directly below the
MENU
text field, would allow the
user to access the
MENU
features.
At anytime during use, pressing the
ENTER
button
(Figure 1)
will allow the user to back up by one screen. Pressing
the
ENTER
button enough times will always take the user back to the main display screen.
To enter the data collection mode press the
AUDIT
button, the unit will
prompt you for
USER NAME
, press soft button immediately under the
Done
text when finished. The unit will list all available tools (files) for
testing. Use the scroll buttons to select tool/file.
Pressing the
CLR
button will return you to the
RUN
or sequential
MEM
mode of the ATDA tester.
Turning On / Off
To turn the
ATDA
on, press the
“ON”
button
(Figure 1)
The AIMCO logo will be displayed for approximately 4 seconds then the
unit will start at the
RUN
or sequential
MEM
mode of the tester.
To turn the
ATDA
off, simply press the
“OFF”
button.
