Page 6
3.2.3.
Corner Bracket Installation
Hold up the corner bracket to the desired installation location
and use it as a template to mark the center of the drill holes.
The hole pattern in shown in Figure 8.
Drill out the eight holes in the mounting surface with a bit
large enough to accept an M8 or 1/4" wall anchor. Drill to an
approximate depth of 3.0 inches (75mm). Insert the wall
anchor (not provided, see Figure 4) into the holes.
Fasten the bracket to the wall. Pass the video, power, and
data (alarm optional) cables through the hole in the bracket as
shown in Figure 9. Feed these cables through the back of the
wall mount and out through the threaded opening. Leave 2-
inches of video cable and 3.5 inches of the other cables
hanging out of the wall mount.
Apply a generous bead of RTV around the entire edge of the
wall mount as shown in Figure 10 as well as the cable hole in
the corner bracket as shown in Figure 9. Fasten the wall
mount to the corner bracket using four M8 x 30mm screws.
Figure 5 – Pendant Mount
Hole Pattern
Figure 6 – Apply RTV Sealant
1
4
0
.0
0
m
m
Figure 8 – Corner Bracket
(Side Plates) Hole Pattern
01 Power/video/data
cables
02 Ceiling Flange
03 Customer supplied
1.5” NPT pipe
shown attached to
Ceiling Flange and
Adapter
04 Wall anchors
05 Set screws
Figure 7 – Pendant Mount
03
02
04
05
05
01
