Page 9
Figure 18 – Apply power and check LED
Figure 19 – Pan/Tilt Module and Packaging
Figure 21 – Heater and Safety Wires
Figure 22 – Attach dome bubble
Figure 20 – Connect PTZ
module into Dome Housing
AMP S ocket
G u id e n o tc h e s
Lo c kin g flan ge s
L o ckin g clip s
Metal Button
LED
Safety line
Heater wire
Heater wire connectors
Captive Screws
3.4.
Pan/Tilt Module Installation
Remove the pan/tilt module from the packaging and inspect it
for damage. If the unit needs to be returned to the factory,
replace it properly in its packaging as shown in Figure 19.
The PTZ module fits into the dome housing quickly and easily.
Line up the AMP sockets shown in Figure 20. The guide
notches will align the module. Carefully press the PTZ module
into position. Two snaps should be audible as it locks into
place.
Hold the dome bubble up to the mounted PTZ unit. If
installing an outdoor unit, connect the heater ring in the dome
bubble to the main unit be connecting the heater connectors
(see Figure 21).
Attach the safety wire from the dome bubble to the main unit
using the M3x5mm screw provided in the hardware kit.
Attach the dome bubble to the main unit by securing the four
captive screws in the trim ring to finish the installation.
