5
1.
Loosen (2) M4 Screws, one on each side, to remove
trim ring and bubble.
Trim ring and bubble are tethered by two wires to
the dome. Carefully remove as to not pull out the
tethers and disconnect the heating unit. Leave
tethers attached.
2.
Remove liner by squeezing and lifting from slot on
each side. Set aside to be replaced after camera
adjustments are made.
5.2
Removing Dome Cover
5.3
Camera Adjustments Day/Night
Camera IND6DN Series
Figure 2
Figure 5
Figure 6
Figure 7
Figure 3
Figure 4
Slot
1.
Set the camera to the desired position by adjusting
the pivot points.This camera module can be adjusted
both vertically and horizontally.The camera module
can also be rotated for proper tilt orientation
Refer to
Figures 5 and 6.
2.
Lens adjustment points. (See enclosed Mfg.
Specifications)
Refer to
Figure 7.
Use the brass
Thumbnuts for tilt
adjustment
Base bracket
adjustment point.
Rotate to adjust
camera bracket
orientation.
Infinity and Near
Wide, Telephoto
Tethered Trim Ring.
Use caution when lifting as
do not dislodge the tethers.
Leave tethers attached
while making adjustments.
