SAGI uses the J30J connector, which leads to more cables, so user needs to pay
attention to the following items
Tie up cables into bundles and take anti-interference measures according to specific
situation.
When connecting the cable to the flight controller, do not pull or push the flight
control to avoid an unpredictable error due to the force. Any performance
degradation or accident caused by that is artificial damage.
User must tighten the connecting screws at both ends to avoid loosening. This must be strictly
checked and it needs to be checked frequently.
GNSS antenna installation
Installation Environment
SAGI supports GPS/GLONASS (or BEIDO) navigation system. The GNSS antenna is a
non-magnetic weak signal receiving device. Please make sure the antenna is not
shielded, otherwise, the signal will be affected. In good cases, it can receive 15~20
satellite signals
Precautions:
1. GNSS antenna should be well connected to FC’s SMA connector. Antenna should
be led out to the top of the drone body, signal receiving surface (black plastic cover)
should be parallel to the ground and facing upto achieve the best performance.
2. The antenna can’t be wrapped/covered with any metal materials like copper foil,
and absorbing material like carbon fiber
3. Antenna feeder cannot be overly bent
4. Keep away from the magnetic field and electric field. Keep away from generator,
servo, high current cable, data link and transmitter
For users who wants to use their own GNSS antenna, please remove the magnet on
the back of the GNSS antenna to avoid any interference caused to the flight
controller
Avoid using any radio equipment in 1.2GHz to 1.6GHz frequency
Installation adjustment