Agromatic ESR-NK Series, Installation And Operating Manual, Page: 30 / 98

4.3 Transport instructions 4 Transportation and storage
24 Actuators NK and VK, Position Controller ESR-NK
4.3 Transport instructions
NOTE
Risk of damaging the actuator!
Improper handling may cause the control shaft of the actuator to be bent.
The control cams installed on the control shaft actuate the limit switches
and the auxiliary switches. Therefore, any modification to the distance
between the shaft and the switches will cause the switching points to be
shifted.
For this reason:
–
Always use the original packaging to transport the actuator.
–
Always transport the actuator with the hood in place.
–
Protect the actuator against strong vibrations such as may occur when
the actuator is dropped.
4.4 Interim storage
The actuator must be stored carefully if it is not set up directly after delivery
or temporarily not used.
−
Always store the actuator in a well ventilated place in a dry room.
−
Protect the actuator from humidity, dust and dirt.
−
The formation of condensation and ice on the actuator must be prevented.
When storing the device for more than 4 months:
−
Apply a long-term anti-corrosive agent on all bare parts of the actuator be-
fore storing it.
−
Place a sufficiently dimensioned humidity absorber inside the actuator.
Important information!
We will not accept any liability for damages caused by improper storage!