10
FIGURE 20
(Left Hand Side View)
FIGURE 18
(Right Hand Side View)
FIGURE 19
(Right Hand Side View)
FIGURE 17
(Left Hand Side View)
CABLE END
FITTING (V)
ENGLISH
STEP 17:
(SEE FIGURE 17)
• From the left side, insert the welded end of the lift handle
rod through the exposed holes in the end of the channel
assembly. Next, insert the lift link pin through the hole
in the bracket that is welded to the lift handle rod. (The
lift link is pre-assembled to the pivot support bracket).
Secure the bracket with a small hairpin cotter.
• Apply a light coating of oil to the straight upper portion
of the lift handle rod. Slide the lift handle tube onto the
rod.
STEP 18:
(SEE FIGURE 18)
• Remove the rubber cap and the first jam nut from the
threaded end of the control cable and slide them onto
the control cable wire. Adjust the second jam nut on the
threads so that it is approximately 3/4" from end. Assemble
threaded end of cable through the cable mount bracket
on the lift handle tube and secure it with the first jam nut.
Reinstall the rubber cap onto the threaded cable end.
NOTE:
Some adjustment of jam nuts may be required
after blade assembly is completed.
STEP 19:
(SEE FIGURE 19)
• Assemble the plastic grip onto the grip assembly.
• Attach the grip assembly to the lift handle tube using
one 5/16" x 1-1/2" hex bolt and one 5/16" nylock nut.
Do not overtighten
the nylock nut. The grip assembly
must pivot freely.
• Assemble the ball end of the cable to a cable end fitting
as was done to the other end of the cable. Secure the
cable end fitting to the weld bolt on the lock release grip
with a 1/4" nylock nut.
Do not overtighten
the nylock
nut. The cable fitting must pivot freely.
STEP 20:
(SEE FIGURE 20)
• Place the long end of the blade pivot rod down through
the blade pivot shaft. Attach the short end of the blade
pivot rod to the lift handle tube. Secure both ends with
small hairpin cotters.
• Use the two plastic ties to hold the cable securely to the
outside of the handle tube and away from the tractor to
avoid direct heat from the tractor muffler.
LIFT HANDLE ROD
HAIRPIN COTTER (N)
LONG PIN
(LIFT LINK)
WELDED BRACKET
LIFT HANDLE TUBE
RUBBER
CAP
CABLE MOUNT BRACKET
JAM NUTS
3/4"
CONTROL CABLE END
5/16" x 1-1/2"
HEX BOLT (D)
PLASTIC
GRIP
1/4" WELD
BOLT
CABLE END
FITTING (V)
5/16" NYLOCK
NUT (H)
1/4 " NYLOCK
NUT (G)
CABLE
GRIP
ASSEMBLY
BLADE
PIVOT
ROD
LIFT HANDLE
TUBE
SMALL HAIRPIN
COTTER (N)
SMALL HAIRPIN COTTER (N)
PLASTIC TIES (Y)
BLADE PIVOT SHAFT
