Agri-Fab LBD48D, Owner'S Manual, Page: 7 / 32

7
STEP 9:
(SEE FIGURE 9)
• Assemble the pivot support bracket to the front of the
Thrust Channel using four 3/8" x 1" carriage bolts and
four 3/8" nylock nuts. Make sure the bracket is straight
and then
tighten.
FIGURE 7
FIGURE 9
FIGURE 8
FIGURE 5
FIGURE 6
ENGLISH
STEP 5:
(SEE FIGURE 5)
• Attach the Rear Locating Bracket to the top of the Rear
Mounting Bracket using two 3/8" x 1" Carriage bolts and
3/8" nylock nuts.
Tighten nuts.
• Attach the Rear Support Channels to the middle set of
holes in the sides of the Rear Mounting Bracket using
four 3/8" x 1" Carriage Bolts and 3/8" nylock nuts.
Finger
tighten only.
REAR SUPPORT
CHANNELS
REAR MOUNTING
BRACKET
REAR LOCATING
BRACKET
3/8" x 1"
CARRIAGE BOLT (F)
3/8" NYLOCK NUT (I)
STEP 6:
(SEE FIGURE 6)
• Slide the Rear Support Channels under the rear of the
tractor. Attach the Rear Mounting Bracket to the Tractor
Drawbar using the 5/8" x 1-3/4" Clevis Pin and a large
Hairpin Cotter.
5/8" x 1-3/4"
CLEVIS PIN (K)
LARGE
HAIRPIN
COTTER (M)
REAR
MOUNTING
BRACKET
REAR LOCATING
BRACKET
REAR SUPPORT
CHANNEL
STEP 7:
(SEE FIGURE 7)
• Slide the Thrust Channel under the front of the tractor.
Attach the Hanger Brackets to the Frame Brackets or
Deck Suspension Brackets using two 1/2" x 1" clevis
pins, 1/2" washers and large hairpin cotters.
STEP 8:
(SEE FIGURE 8)
• Place the Thrust Channel between the two Rear Support
Channels. Install four 3/8" x 1" carriage bolts and 3/8"
nylock nuts using the most widely spaced holes that
align with slots.
Finger tighten only.
• If the Rear Support Channels bump against the bottom
of the tractor, reattach the rear of the channels to a lower
set of holes in the Rear Mounting Bracket. If there is more
clearance than necessary between the Rear Support
Channels and the bottom of the tractor, reattach the
rear of the channels to a higher set of holes in the Rear
Mounting Bracket.
• Tighten all bolts and nuts installed up to this point.
• Measure the height of the front plate on the Thrust
Channel. If it is not 4" to 5" above the ground, reinstall
the clevis pins in the Hanger Brackets to a higher or
lower hole position to attain the correct height.
THRUST
CHANNEL
1" x 1/2" CLEVIS
PIN (L)
LARGE HAIRPIN
COTTER (M)
1/2" WASHER (S)
REAR
SUPPORT
CHANNELS
FRONT
PLATE
3/8" x 1"
CARRIAGE BOLT (F)
3/8" NYLOCK
NUT (I)
4" to 5"
GROUND
3/8" x 1"
CARRIAGE BOLT (F)
3/8" NYLOCK
NUT (I)