Agri-Fab 45-0331, Owner'S Manual

Page: 8 / 24

8
IMPORTANT: Do not over bend the support rods during
the following step. Over bending will cause the steel rods
to loose supporting tension.
10. (Figure 15) Tip the hopper onto it's back to assemble
the two hopper support rods. Place the ends of each
rod into the upper and lower rear hopper tubes, bending
the rod just enough to fi t into the holes in the tubes.
SUPPORT
RODS
15
7. (Figure 13) Insert the bag frame strap into the stitched
sleeve along the front edge of the bag bottom.
8. (Figure 13) Assemble the bag frame strap to the lower
hopper side tubes using two 1/4" x 1-1/8" clevis pins
(Q) and 3/32" hair cotter pins (O).
SNAP
FLAP
FIGURE 14
9. (Figure 14) Secure the bag corners around the lower
hopper side tubes by snapping the bag fl aps to the bag
bottom on both sides.
5. (Figure 12) Place the assembled lower hopper tubes
into the bottom of the hopper bag.
6. (Figure 12) Attach the ends of the lower hopper side
tubes to the inside of the upper hopper side tubes using
two 3/8" x 1/2" clevis pins (P) inserted from the inside,
and two 3/32" hair cotter pins (O).
12
LOWER HOPPER
SIDE TUBE
HOPPER BAG
BOTTOM
UPPER HOPPER
SIDE TUBE
3/8" x 1/2"
CLEVIS PIN (P)
3/32" HAIR
COTTER PIN (O)
13
1/4" x 1-1/8"
CLEVIS PIN (Q)
3/32" HAIR
COTTER PIN (O)
BAG FRAME STRAP
14
ENGLISH