Agri-Fab 45-03291, Owner'S Manual

Page: 9 / 24

9
ENGLISH
27. For most vehicles, assemble the hitch extension bracket
to the holes in the hitch tube shown at the
top
of figure
16. Use two 1/4" x 1-3/4" hex bolts (B) and 1/4" nylock hex
nuts (F) tightened only finger tight. Attach the spreader
hitch to your vehicle hitch. Check for interference with
the spreader directly behind and out to both sides of
the vehicle. Lift the spreader at each position to make
sure there is no interference with the spreader's flow
control. If there is interference with the rear of the vehicle,
assemble the hitch extension bracket as shown at the
bottom
of figure 16.
Tighten
the bolts and nuts when
finished.
FIGURE 16
(F) 1/4" NYLOCK
HEX NUT
(B) 1/4" x 1-3/4"
HEX BOLT
24. Place the screen down into the hopper, sliding the edge
of the screen under one of the clips. Slightly bow the
screen to slide the opposite side of the screen under
the other clip. See figure 14.
FIGURE 14
25. Assemble the hitch bracket to the hitch extension bracket
using two 3/8" x 3/4" hex bolts (C) and 3/8" nylock hex
nuts (H). Insert the bolts from the bottom. See figure
15.
26. Assemble the hitch pin (O) through the hitch bracket
and the hitch extension bracket and secure with the
hair cotter pin (N). See figure 15.
FIGURE 15
(C) 3/8" x 3/4"
HEX BOLT
(H) 3/8" NYLOCK
HEX NUT
(O) HITCH PIN
(N) 1/8" HAIR
COTTER PIN
CLIPS
CLIP
SCREEN