12
CONNECTING THE CAMERA
FL360 is has two operational modes: wireless and wired. The wireless mode is the preferred method as it
allows the operator(s) more freedom of movement. The wired mode can be used if the signal quality of the
wireless mode is adversely affected by interference of structures or competing wireless signals.
Wireless Operation (USAR and RSK)
Step 1
Ensure all FL360 batteries and the tablet are fully charged. See CHARGING PROCEDURES on page 10 for
detailed instructions.
Step 2
Once the batteries are fully charged, take the provided FL360 Battery Compartment Tool (fig 2) (or any 4mm
hex socket tool), unscrew both 4mm screws, and remove the battery lid from the FL360 Camera housing (fig
3).
Step 3
Insert two (2) fully charged FL360 Batteries over the orange ribbon into the camera, while carefully observing
polarity by lining up the red (positive) side of the FL360 Battery with the positive terminal in the battery
compartment (fig 4, 5 & 6). The FL360 Batteries should be inserted top of the orange ribbon to allow for easy
battery removal. Tuck the excess ribbon back in between the batteries (fig 7) to avoid interference with the
sealing gasket of the battery lid.
NOTE
: Always remove FL360 Rechargeable Li-ion Batteries after use. Batteries left in the FL360 Camera will
discharge even if the camera has been turned off.
Figure 2: FL360 Battery Compartment Tool
Figure 3: Unscrew the 4mm screws on the Battery Lid.
Figure 4
Figure 5
Figure 6
Figure 7
