Introduction
1
Agilent U9391C/F Comb Generator Operating and Service Manual
11
Options
There are two connector options available for Agilent
U9391C/F.
Service and Recertification
If your Comb generator modules require service or
recertification, contact the nearest Agilent office for
information on where to send it. Refer to “ Contacting Agilent”
in the front matter of this manual. The performance of the comb
generator modules can only be verified by specially
manufactured equipment and calibration standards from
Agilent.
Recertification of Comb Generator Modules
The suggested interval for recertification is 12 months. After
reviewing the result of the initial recertification, you may
establish a shorter interval that reflects greater use and wear of
the module.
Table 1-1
Options for Agilent U9391C/F
Option
U9391C
U9391F
Option FF
F
3.5mm Female (Output
connector)
2.4mm Female (Output
connector)
Option FF
M
3.5mm Male (Output
connector)
2.4mm Male (Output
connector)
N O T E
The Trigger and Input ports are of
3.5mm
Female connectors, for all the
options above
Summary of Contents for U9391C
Page 1: ...Agilent Technologies Agilent U9391C F Comb Generator Operating and Service Manual ...
Page 6: ...6 Agilent U9391C F Comb Generator Operating and Service Manual ...
Page 12: ...12 Agilent U9391C F Comb Generator Operating and Service Manual 1 Introduction ...
Page 30: ...30 Agilent U9391C F Comb Generator Operating and Service Manual 3 Specification ...
