Agilent Technologies N9342C, User Manual

Page: 140 / 179

5 Key Reference
132 N9342C/43C/44C User’s Guide
•
Lower Limit
Sets the lower test limit value for the current
measurement. The units used are dependent on
the current setting of power unit. When the
measured power is less than the value specified,
a failure will be reported.
•
Limit Beep
Enables or disables the limit beep.
•
Rel/Offset
Accesses the
Rel/Offset
submenu.
•
Rel
Enables the comparison of a measurement result
to a reference value and sets a reference value
on the current measured data.
•
Offset
Sets a value of the display offset on the current
measurement, and enable or disable the display
offset. The display offset is applied to the
measurement signal after any math calculation.
•
Average
Accesses the
Average
submenu.
•
Average
Enables or disables the
Average
function.
•
Avg Count
Sets a value of the filter length and to set the
average count value to be Auto or Manual.
The power sensor automatically sets the number
of readings averaged together to satisfy most
power measurements averaging requirements.
The number of average readings depends on the
resolution and the power level settings the
power sensor is currently using.
•
Step Detect
Enables or disables step detection. In AUTO
filter mode, the average of the last four values
entered into the filter is compared to the entire
filter average. If the difference between the two