SYSTem Commands
*LRN?
Returns a sequence of SCPI commands that can later be used to put the instrument in the same state that it was in
when the *LRN? query was sent. The scope of the returned settings is the same as for the *SAV and *RCL commands.
Parameter
Typical Return
(none)
ASCII string with semicolon-separated fields
Returns the sequence of SCPI commands: *LRN?
l
To read the string into your computer, be sure to dimension a string variable with at least 2500 characters.
*OPT?
Returns a string identifying any installed options. A 0 (zero) indicates no options are installed.
Parameter
Typical Return
(none)
OPT 760
Returns installed options: *OPT?
*RCL <0-9>
Restores the instrument to a state that was previously stored in memory locations 0 through 9 with the *SAV com-
mand. All instrument states are recalled except: (1) the trigger system is set to the Idle state, (2) calibration is dis-
abled, (3) trigger settings are set to their Idle state, and (4) non-volatile settings are not affected..
Parameter
Typical Return
0 - 9
(none)
Recall state from location 1: *RCL 1
l
Location 0 is automatically recalled at power turn-on when the Output Power-On state is set to RCL 0.
l
You cannot recall an instrument state from an empty or deleted storage location.
l
Stored instrument states are affected by *RST.
SHOCK HAZARD If the output is enabled when an instrument state is saved to location
0 (zero), the output will automatically be enabled at turn-on if the power-on state is
set to RCL 0.
*RST
Resets the instrument to pre-defined values that are either typical or safe. These settings are described in
Factory
Reset State
.
Agilent N8900 Series Operating and Service Guide
95
Summary of Contents for N8900 series
Page 1: ...Agilent N8900 Series Autoranging System DC Power Supply Operating and Service Guide...
Page 36: ...Multiple Unit Connections Agilent N8900 Series Operating and Service Guide 35...
Page 104: ...Status Tutorial Status Diagram Agilent N8900 Series Operating and Service Guide 103...
Page 119: ......
