Analog Port Connections
Analog Port Connections
Analog connections are made through the 15 pin analog connector (Type: Sub-D, D-Sub) on the rear of the unit. Use a
standard connector plug (customer-supplied) to make all connections. Remember to turn of the unit before making
any rear panel connections.
Equipment Damage
The analog interface is galvanically separated from DC output and referenced
to earth ground. Therefore never connect a ground from the analog interface to the +DC or -DC out-
puts. Use an isolated, ungrounded, programming source to prevent ground loops when using the
analog interface.
Pin Assignments
The following figure identifies the pins on the analog port.
You must provide the mating plug that for the analog connector. Use a 15-pin D-subminiature connector.
For information on using the analog functions refer to
Analog Programming
.
Agilent N8900 Series Operating and Service Guide
37
Summary of Contents for N8900 series
Page 1: ...Agilent N8900 Series Autoranging System DC Power Supply Operating and Service Guide...
Page 36: ...Multiple Unit Connections Agilent N8900 Series Operating and Service Guide 35...
Page 104: ...Status Tutorial Status Diagram Agilent N8900 Series Operating and Service Guide 103...
Page 119: ......
