Installation Note E8362-90016
13
Step 6. Raise the Receiver Deck
1. Place the analyzer bottom-side up on a flat surface.
2. Using a T-10 TORX driver, remove the four screws, (item
①
), that secure the receiver deck.
3. Pull the latch pin (item
②
) towards the opposite side of the analyzer to release the receiver
deck.
4. Lift the receiver deck to partially raise it, then release the latch pin (item
②
). Lift the
receiver deck to its fully raised position and ensure that the latch pin latches in the raised
position.
Figure 6
Receiver Deck Raising
