Agilent Technologies E1437A, User Manual, Page: 159 / 214

LBUS:MODE command/query
Set and query local bus mode.
Command Syntax: LBUS:MODE <mode>
mode::=0

1

2

3
Query Syntax: LBUS:MODE?
Example Statements:
OUTPUT 70924;"Lbus:Mode 2"
Description: LBUS:MODE sets the local bus to either generate, append, insert or pipeline data.
Th e data port must be set to th e local bus with th e DATA:PORT command before
these modes take effect.
Parameter Definitions:
selects th e transmission mode of th e local bus wh en it is enabled by th e
DATA:PORT command. The state of this parameter is unaffected by switching back
and forth between the local bus and the VME backplane with the DATA:PORT
command.
parameter
value
mode parameter definition
0
PIPELINE causes the E1437 to pipe data through from modules on its left without
appending or inserting its own data.
1
GENERATE forces the module addressed to generate data only, not passing through data
from other modules on the local bus
2
APPEND causes the E1437 to pass through data from modules on its left and append its
data to the end
3
INSERT causes the E1437 to place its data on the local bus and then pass through data
from modules on its left.
Reset Values: lbusMode =PIPELINE
See Also:
DATA:PORT
Module to Right HP E1437 Module(s) to Left
PIPELINE
INSERT APPEND
GENERATE
E1437A LBUS:MODE
ASCII Overview and Commands command/query
5-36
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com