64
P1512134 R2
Figure 31.
Diagonal Pattern for 4-bolt and 6-bolt Tires
1
2
3
4
1
2
3
6
4
5
7.21. Inspect and Service the Hand Winch and Lift Cable
Æ
When equipped:
Place conveyor in fully lowered position with cable slack.
1. Inspect the cable for damage such as fraying, kinking, or unwinding. Replace if damaged (see below).
2. Check to make sure cable clamps are secure.
3. Oil cable pulleys as needed.
4. Keep a film of grease on the gears. Occasionally oil the bushings, drum shaft, and ratchet.
5. Do not get oil or grease on brake discs.
6. Replace brake discs if less than 1/16" (1.6 mm) thick.
7. Check for proper ratchet pawl operation:
•
When cranking in (clockwise) = loud clicking
•
When cranking out (counterclockwise) = no clicking and ratchet pawl fully engaged into gear teeth.
To Replace the Lift Cable:
1. Unwind the winch drum until cable is slack and remove all cable clamps.
2. Free the cable from the winch and pulleys.
3. Remove the cable clamps that secure the hook in place.
4. Reverse the above steps to install the new cable.
7.22. Pinion Gear Adjustment
Æ
When Equipped:
The pinion gear should mesh with the ring gear to provide maximum tooth contact. If the pinion gear does not
mesh entirely with the ring gear:
S-DRIVE FIELD LOADER – PORTABLE GRAIN BELT CONVEYOR
