P1512134 R2
41
Figure 14.
Wheel Move Kit Controls (1800 and 2400 Series)
1
4
3
2
4
2
3
1
If Operating the Wheel Move Kit in Temperatures Below -10°C (14°F):
• Disengage the pump when starting the motor cold. This will put less pressure on the starter and allow the
motor to turn over easier, helping it to start.
• Allow the hydraulic oil to warm before using the self-propelled kit.
Failure to warm the hydraulic oil can damage the pump or other components.
When Operation of the Wheel Move Kit is Complete:
1. Secure the wheel move kit axle to the conveyor when operation is complete or before transporting.
2. Fully disengage the over-center handles and secure the handle with the attached pin, see
.
Do not transport with the over-center handles engaged or damage to the wheel move kit
motors will occur.
Figure 15.
Chain Position
3. Disengage the pump to take the strain off the conveyor drive components.
S-DRIVE FIELD LOADER – PORTABLE GRAIN BELT CONVEYOR
